вторник, 25 февраля 2020 г.

DIGORA OPTIME DRIVERS DOWNLOAD FREE

You have to send the unit to factory for repair. Belt tightness is now in lower limit one ring is shown. Press start button at K board. During boot the system makes initialization and self test. Following codes are displayed. Only service personnel trained and approved by the manufacturer of the unit are allowed to service the unit. digora optime drivers

Uploader: Kajisida
Date Added: 3 January 2006
File Size: 34.40 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 48964
Price: Free* [*Free Regsitration Required]





Scanora 3Dx Pre-Installation Guide. Then restart the unit and scan an image plate. Install the readout head belt as in images. The pulse does not come if the photo diode is broken or the laser does not hit the lower photo diode in K board.

digora optime drivers

The clip spring force locks the clip hole to the chassis. Wait until s2terminal tells that upgrade is finished 6. The unit must not be positioned so that it is touching other equipment.

After calibration quit from service mode and turn the unit off and again on.

DIGORA Optime DXR Field Service Manual |

Detach laser connector and release the cable from all six cable holders 8. If after reassembly safety switch error occurs the light cover might be raised from the chassis. Bigger value moves image left in application window, smaller value right. Belt tightness is now in perfect 2 rings. For that move the plate carrier backwards and move the door by hand.

Now scanning begins when you press the start button but without checking that the image plate is installed correctly. Following commands are needed to upgrade FW.

Install the new K Check that the light cover is tightly to the chassis.

Open Dental Software - Digora Soredex Optime Bridge

Push it into the light collector up to the stop. Do not use any other numerical parameters after test-command!

digora optime drivers

Remove the main and front covers. Seeger lock ring 2 pcs L.

DIGORA Optime DXR-60 Field Service Manual

Make sure that the cable is pushed in bottom of the connector and the connector locking clip is properly closed. Connect the power adapter, connect the device to PC, start S2terminal and turn the device on.

digora optime drivers

Scanner IP address configuration is started 5. Check that the PMT tube is pushed inside the light collector so that this hole is plugged.

Use demo image mode for demo purposes with unexposed plates. Remove the back and front covers 2. Lift the clip of the upper shaft and remove the shaft. To enable the bridge: When carriage moves forward it should open the door and when backwards the door should be closed. Release the locking by pressing the tab 1 at the back side of the plate carrier and simultaneously turning adjustment screw slightly clockwise 2 frivers then releasing the black belt mechanism 3.

Remark that it goes only in correct position. High voltage can be set on when the light beam of opto safety switch is blocked. Motor Holder Assembly K.

Double click on Additional Properties to change settings. Needed only if belt is too tight.

After testing, repair or adjustment, check that the unit is restored to the conditions necessary for normal use.

Комментариев нет:

Отправить комментарий